Rockwell Automation 6189 Accessory Mounting Brackets and Covers for 6180 Computers - Manual (Page 15)

Accessory Mounting Brackets and Covers 15
The CD ROM covers provide protection for the part of the drive that
extends from the 6180 computer chassis. Two cover kits are
available:
•
Cover Kit for Front Mounting of CD ROM
(Catalog No. 6189-FCDBRKT for Series A;
Catalog No. 6189-FCDBRKTB for Series B)
•
Cover Kit for Rear Mounting of CD ROM
(Catalog No. 6189-RCDBRKT for Series A;
Catalog No. 6189-RCDBRKTB for Series B)
Installation
Note: There are two bags of screws provided with the bracket. Use
the three flush head mounting screws to mount the covers. Use the
remaining four screws to secure the CD ROM drive.
Use this front cover when a CD Drive is rear mounted.
The cover mounts under the front access door to protect
the rear of the CD drive.
Use this rear cover when a CD Drive is rear mounted.
The cover mounts to the back panel to protect the front of
the CD drive while allowing access to the drive.
Catalog No. 6189-RCDBRKT
Catalog No. 6189-RCDBRKTB
Catalog No. 6189-FCDBRKT
Catalog No. 6189-FCDBRKTB
Use this rear cover when a CD Drive is front mounted.
The cover mounts on the back panel to protect the rear
of the CD drive.
To install a rear cover:
1. Remove the back panel to the 6180 computer.
2. Position the cover on the inside of the back panel.
3. Secure the cover with the screw provided. Tighten screw to a
torque of 6-8 in. lbs (.7-.9 N
Sm).
4. Install the back panel.
To install a front cover, refer to the instructions on page 8.
To install a CD ROM, refer to the instructions on page 4.
CD ROM Covers