Rockwell Automation 6189 Accessory Mounting Brackets and Covers for 6180 Computers - Manual (Page 3)

Accessory Mounting Brackets and Covers 3
!
ATTENTION: Remove all cables from the side panel
connectors. Failure to remove cables may cause
damage to the cables and connectors.
!
ATTENTION: If the 6180 Computer is installed with
mounting clips, the mounting clips on the hinge side
will interfere with the opening of the hinge. Remove
the mounting clips on the hinge side before swinging
chassis away from the bezel. Failure to remove clips
may damage clips and the chassis.
2. Swing open the back of the computer chassis after removing the
three bezel latching screws. Refer to 6180 computer user manual
for instructions if required.
Chassis Swings Away
From Bezel Cover Knockout
for Rear Mounting of Drive
Front Bezel
Latching Screws (3)
3. Position the accessory drive / bracket assembly into the chassis.
Notes:
For rear facing drives, you may have to remove the panel
knockout (shown above) if a rear mounted drive was not
previously installed. Insert screwdriver into slot on knockouts
and pry back and forth on knockout to remove. Use a pliers to
remove the center rib between the two knockouts.
For front facing drives, if a floppy drive was not previously
installed, you may have to replace the floppy drive cover behind
the front access door with a cover having an opening. Refer to
Floppy Drive Front Cover on page 7 for a description of the
available covers.