Rockwell Automation 6189 Accessory Mounting Brackets and Covers for 6180 Computers - Manual (Page 7)

Accessory Mounting Brackets and Covers 7
The floppy drive cover plates provide protection for installed floppy
drives.
•
Floppy Drive Cover Plates
(Catalog No. 6189-FDDCVR for Series A;
Catalog No. 6189-FDDCVRB for Series B)
There are four floppy drive cover plates (2 front covers, 2 rear
covers). Use the cover plates as follows:
Use this front cover when Floppy Drive is front mounted.
The cover mounts under the front access door to protect
the front of the floppy drive.
Use this front cover when Floppy Drive is rear mounted or
not installed. The cover mounts under the front access
door to protect the rear of the floppy drive or to prevent
access to the inside of the computer.
Use this rear cover when front mounting a floppy drive or
if a floppy drive is not installed.
Use this rear cover when a floppy drive is rear mounted.
To install the rear cover plate:
1. Remove the back panel to the 6180 computer.
2. Position the cover on the inside of the back panel.
3. Secure the cover with the screw provided. Tighten screw to a
torque of 6-8 in. lbs (.7-.9 N
Sm).
4. Install the back panel on the 6180 computer.
Floppy Drive Cover Plates