Rockwell Automation 6189 Accessory Mounting Brackets and Covers for 6180 Computers User Manual
Page 11
Advertising
Accessory Mounting Brackets and Covers
11
4. Install the ribbon connector on the hard drive. On 3.5 inch drives
also connect the power cable. Make sure that the ribbon cable is
installed correctly. The red wire of the cable must be at the
bottom as shown below:
Drive
Ribbon Connector
Red Wire
5. Install the back panel.
6. Apply power to the 6180 Computer and verify operation of the
drive. You may need to edit BIOS settings to recognize the drive
or to allow the operating system to detect the new hardware.
Advertising