Rockwell Automation 2755 StrataSet Programming Software - Manual (Page 31)

2–20 Configuring your Reader
Publication 2755-6.14
RS232 Type Description
Options Nixdorf ID
When this option is enabled, the reader transmits Nixdorf code
identifiers before each bar code as follows:
Code Prefix Code
UPC-E d
UPC-A c
EAN-8 g
EAN-13 h
Code 39 b
Codabar a
Code 93 i
I 2 of 5 e
Code 128 j
RTS/CTS handshaking
When this option is enabled, the reader outputs a Request To
Send (RTS) signal and waits for a Clear To Send (CTS) signal
before any data is transmitted.
RTS/CTS (character)
When this option is enabled, the reader activates and
deactivates its RTS signal after each character it transmits.
RTS/CTS (message)
When this option is enabled, the reader activates and
deactivates its RTS signal after each message it transmits.
ETX suffix
When this option is enabled, the reader transmits an End of
Text after each bar code.
STX prefix
When this option is enabled, the reader transmits a Start of
Text before each bar code.
Tab prefix
When this option is enabled, the reader transmits a TAB
before each bar code.
Tab suffix
When this option is enabled, the reader transmits a TAB after
each bar code.
UPC prefix
When this option is enabled, the reader transmits a prefix
before any UPC/EAN bar codes. The prefixes are A (UPC A),
E0 (UPC E), F (EAN 13), and FF (EAN 8).
UPC suffix
When this option is enabled, the reader transmits a suffix after
any UPC/EAN bar codes. The suffixes are A (UPC A), E0
(UPC E), F (EAN 13), and FF (EAN 8).
Schlumberger/Shell format
When this option is enabled, the reader transmits an XOR’ed
check digit of all the data characters at the end of the data
stream.
Table continued on the next page.