Rockwell Automation 2755 StrataSet Programming Software - Manual (Page 33)

2–22 Configuring your Reader
Publication 2755-6.14
RS232 Type Description
Options Transmit Sanyo ID Character
When this option is enabled, the reader transmits special code
identifiers before each bar code as follows:
Code Prefix Code
UPC-A C
EAN-8 A0
EAN-13 B
Code 39 A
Codabar
M plus 2–digit hexadecimal
representation of the
character count
Code 93
L plus 2–digit hexadecimal
representation of the
character count
I 2 of 5
I plus 2–digit hexadecimal
representation of the
character count
Code 128
K plus 2–digit hexadecimal
representation of the
character count
SNI Beetle Mode This feature is not currently supported.
French PC Terminal Emulation This feature is not currently supported.
Xon/Off handshaking
When this option is enabled, the reader does not transmit after
an XOFF is received. Transmission resumes after an XON is
received.
Programmable prefix identifiers
When this option is enabled, one or two programmable prefix
ID characters can be assigned and added to the scanned data
transmission. To assign the character, refer to the options
Xmit (Transmit) as 1st prefix identifier or Xmit as 2nd prefix
identifier below.
Transmit as 1st or 2nd prefix
identifier
When the Programmable prefix identifiers option is enabled, a
programmable prefix ID character can be entered in either of
these 2 windows. (The decimal equivalent of the ASCII value
of the key pressed is then displayed).
Programmable suffix identifiers
When this option is enabled, one or two programmable suffix
ID characters can be assigned and added to the scanned data
transmission. To assign the character, refer to the options
Xmit (Transmit) as 1st suffix identifier or Xmit as 2nd suffix
identifier.
Transmit as 1st or 2nd suffix
identifier
When the Programmable suffix identifiers option is enabled, a
programmable suffix ID character can be entered in either of
these 2 windows. (The decimal equivalent of the ASCII value
of the key pressed is then displayed).