Rockwell Automation 2711E-NKSW1 Replacement Keyswitch Assembly - Manual (Page 14)

40061-135-01(C)
14 Replacement Keyswitch Assembly
PV1200 Terminals Series F
through Series G,
All PanelView 1200e Open the Logic Board Drawer
1. Place the terminal on its side on top of a protective surface.
2. Remove the two screws which hold the logic board drawer
closed.
3. Swing the drawer open.
Disconnect the Logic Board
Remove the connections from points J1, P1, P2, P3 and J6 on the logic
board.
Remove these
screws to access
the logic board.
PanelView 1200 Terminals
Keyswitch
J1
P3
J6
Squeeze the clips and
slide them out to loosen
the connector, then pull
out the ribbon cable.
P2 P1