Rockwell Automation 2711E-NKSW1 Replacement Keyswitch Assembly - Manual (Page 19)

40061-135-01(C)
Replacement Keyswitch Assembly 19
Remove the Logic Board Drawer
Carefully pull on one side of the drawer (side opposite green ground
wire) to dislodge the hole in the drawer from the rounded protrusion
on one side of the chassis.
Note: Be careful that you don’t damage the copper finger strip or
ground wire.
Remove the Logic Board
Remove the seven phillips screws holding the logic board to the
drawer and slide out the logic board.
Remove the Keyswitch
Using a 7/8 inch wrench, remove the nut securing the keyswitch.
Remove the keyswitch.
Pull on this side
Dislodge Drawer
from Chassis
Ground Wire
Copper Finger Strip
ATTENTION
!
Do not hold the keyswitch by the plastic section of
the body. Twisting the plastic section can damage
the keyswitch.