Rockwell Automation 2711E-NKSW1 Replacement Keyswitch Assembly - Manual (Page 15)

40061-135-01(C)
Replacement Keyswitch Assembly 15
Remove the Logic Board Drawer
The drawer hinges are white nylon bushings held in place by a
phillips screw.
1. Remove the screw from the top hinge (the one opposite the side
with the ground wire). Using needle nose pliers, pinch the
prongs on the bushing and push the bushing upwards, out of
the metal tab.
2. Swing the drawer outwards, and the other bushing will detach,
allowing the drawer to be removed. The ground wire can
remain attached.
Remove the Logic Board
1. Remove the ten phillips screws holding the logic board to the
drawer and slide out the logic board.
IMPORTANT
PanelView 1200 - When removing the logic board
mounting screws, note that the screw located below
U7 has a plastic washer. This washer must be
installed in the same position during reassembly.