Rockwell Automation 2711E-NKSW1 Replacement Keyswitch Assembly - Manual (Page 16)

40061-135-01(C)
16 Replacement Keyswitch Assembly
PV1200 Terminals Series F
through Series G,
All PanelView 1200e
(Continued) Remove the Keyswitch
Using a 7/8 inch wrench, remove the nut securing the keyswitch.
Remove the keyswitch.
Insert the New Keyswitch
1. Slide in the replacement keyswitch and secure it to the drawer
with the nut.
2. Orient the keyswitch so that the key’s teeth face upwards. Align
the two flat surfaces of the switch with the two flat edges of the
opening in the drawer.
Reassemble the Terminal
1. Position the logic board in the logic board drawer and secure
with ten screws.
2. Reattach the bushing and put the drawer back into the terminal.
3. Reconnect the logic board ribbon cables and wire connectors:
Reattach the ribbon cables (J6 and J4) to the logic board. With
the locking bars up, hook each cable onto the tabs in the
ATTENTION
!
Do not hold the keyswitch by the plastic section of
the body. Twisting the plastic section can damage
the keyswitch.