Rockwell Automation 2711E-NKSW1 Replacement Keyswitch Assembly - Manual (Page 7)

40061-135-01(C)
Replacement Keyswitch Assembly 7
Remove the Keyswitch
Using a 7/8 inch wrench, remove the nut securing the keyswitch.
Remove the keyswitch.
Insert the New Keyswitch
1. Slide in the replacement keyswitch and secure it to the drawer
with the nut.
2. Orient the keyswitch so that the key’s teeth face upwards. Align
the two flat surfaces of the switch with the two flat edges of the
opening in the drawer.
ATTENTION
!
Do not hold the keyswitch by the plastic section of
the body. Twisting the plastic section can damage
the keyswitch.