Rockwell Automation 7703E Medium Voltage SMC OEM Components - 10-15 kV - Manual (Page 9)

Rockwell Automation Publication 7703E-IN001E-EN-P - July 2014 9
Chapter
2
Receiving and General Information
Receiving Refer to Getting Started, General Handling Procedures for Medium Voltage
Controllers – Publication
MV-QS050_-EN-P . This document is included with
your shipment and contains information regarding receiving, unpacking, initial
inspection, handling, storage, and site preparation.
Handling Procedures for
Electrostatic Sensitive
Devices
To guard against electrostatic damage (ESD) to equipment, the following
precautions should be observed when handling electrostatic sensitive devices.
1. Use a grounding wrist strap to minimize the build up of static charges on
personnel.
2. Handle the module by the edges and avoid touching components or
printed circuit paths.
3. Store devices with sensitive components in the conductive packaging that
the module is shipped in.
These precautions are the minimum requirements for guarding against ESD. For
more information refer to Guarding Against Electrostatic Damage –
Publication ICCG-4.3. See the Additional Publications section for information
on obtaining this document.
Standards and Codes
• CEC (Canadian Electrical Code)
• CSA 22.2 No. 253 (Canadian Standards Association) – Medium Voltage
AC Contactors, Controllers and Control Centers
• NEC (National Electrical Code)
ATTENTION: Printed circuit boards contain components that can be damaged
by electrostatic charges that build up on personnel during normal activities.
Exercise the following precautions when handling electrostatic sensitive
devices. Failure to do so may damage the device and render it inoperable.
IMPORTANT It is recommended that the user be familiar with the following safety and
design standards and codes, and any additional local codes that a medium
voltage controller must comply with: