Delete old computer name – Rockwell Automation 9528-APPOWSENE Virtual Image Templates User Manual User Manual
Page 110
110
Rockwell Automation Publication 9528-UM001C-EN-P - March 2014
Chapter 5
Configure Application Server Historian
14.
Click Finish.
15.
At the FactoryTalk Historian Asset Framework window, click Exit.
Delete Old Computer Name
After you have installed the Historian Asset Framework, you need to delete the
old computer name. Perform the following steps.
1.
Click Start and choose >All Programs>Rockwell Software>
FactoryTalk Historian SE>FactoryTalk Historian SE System>
PISDK Utility. The PI Software Development Kit window opens.
IMPORTANT
At this point, if you are not planning on implementing a
FactoryTalk Historian SE collective, then proceed with the steps in this section
and the Synchronize AF Database section.
If you are planning on implementing a collective, then please refer to
Knowledgebase Answer ID 60585 - FactoryTalk Historian SE Collective Manager
Error - Error Writing Server
for additional steps to take. This document can also be found in the PlantPAX
Documentation folder in your template.
You must have a TechConnect license to view this article.
Asset Framework needs to be installed on a separate computer if you have
implemented a collective. After AF has been installed on a separate computer,
skip the steps in this section and perform the steps in the MDB to AF
Synchronization section.
TIP
The first time the PI SDK is run, it can take several minutes to complete the
startup and show a display.