Rockwell Automation Liqui-Flo Control Configuration Software Version 6.0, M/N 2CS3000 - Manual (Page 20)

2-6 Control and Configuration Software V6.1
Using Windows 98:
• From the Start menu, choose Programs and Control and Configuration.
The CS3000 Main Window is displayed as shown in Figure 2.4.
The CS3000 software tries to establish communication with the drive.
Figure 2.4 – Sample Main Window for an Established Connection
If communication is: Then:
established • The drive type (GV3000, Liqui-Flo, or FlexPak 3000) and version is
displayed in the Selected Drive field.
• “UNTITLED” is displayed in the Opened configuration field.
• Drives that have Vector or Volts/Hertz options display the currently
selected option.
• “Connected” is displayed on the right side of the main window.
• The configuration on the drive is uploaded to the personal
computer.
• The drive status window is automatically opened. See section 6.2
for more information.
not established • The Selected Drive field displays either “UNTITLED” or the drive
that was selected the last time the CS3000 software was run. If the
Selected Drive field displays “UNTITLED,” you must select a drive.
See chapter 3 for more information.
• “Disconnected” is displayed on the right side of the main window.
• “UNTITLED” is displayed in the Opened Configuration field.
• Drives that have Vector or Volts/Hertz options display the currently
selected option.