Rockwell Automation Liqui-Flo Control Configuration Software Version 6.0, M/N 2CS3000 User Manual
Page 90
A-2
Control and Configuration Software V6.1
The connected drive is not supported.
This error is displayed if the CS3000 software attempts to connect to a drive that
returns an unrecognized drive type.
Parameter(s) not relevant for the current control type found in the monitor list
have been ignored.
This message is displayed if a monitor list is recalled that was used for a different
control type than the one currently selected. Only parameters that are specific to the
currently selected control type are displayed.
The file was created for an unknown drive.
This error is displayed if you attempt to open a configuration file that was created for a
drive that is not recognized by the CS3000 software.
Communication error.
Can occur when the CS3000 software is communicating with the drive via the serial
communication connection. Check the cables, drive power, and the COM port
selection.
Parameter value is invalid.
Indicates a parameter value syntax error.
Parameter value has not been entered.
Indicates a missing parameter value.
Parameter value is out of range.
Indicates an out of range parameter value.
COMMUNICATION ERROR MESSAGES
Unknown response from the drive.
Displayed if the drive returns a response error code that is not recognized by the
CS3000 software.
Operation cannot be performed while drive is running.
The operation that was attempted cannot be done if the drive is running. You must
stop the drive to perform the operation.
Operation cannot be performed during download.
The operation that was attempted cannot be done if a download to the drive is in
progress.
ID format is invalid.
Version format is invalid.
These messages indicate that the response to a request to the drive for its type and
version is invalid.
A parameter VDR index was invalid.
If this error occurs, the CS3000 software attempted to read or write to a parameter
with an invalid index number. This could indicate that the memory in the computer has
been corrupted or that the CS3000 software itself is corrupted.
Download cannot be performed while the drive is running.
This message is displayed if a download is attempted when the drive is running. The
drive must be stopped before a configuration can be downloaded.