Rockwell Automation Liqui-Flo Control Configuration Software Version 6.0, M/N 2CS3000 - Manual (Page 59)

Monitoring and Editing Drive Parameters 6-7
6.6 Displaying a Monitor List
To display a previously-saved monitor list in the CS3000 Parameter Monitor screen,
use the Recall button. The monitor list file must have been created and saved. Any
parameters currently being displayed in the Parameter Monitor are replaced by the list
of parameters read in from the monitor list file. Figure 6.4 shows the Recall Monitor
List dialog box.
Use the following steps to read and display a Monitor List file:
Step 1. Select the drive and directory path that contains the monitor list files.
Step 2. If the monitor list files were saved using a file extension other than .MON,
select *.* in the List Files of Type box to display all of the files.
Step 3. Enter a file name, or select the file name from the displayed list.
Step 4. To recall the file and display it in the Parameter Monitor window, select OK.
To close the dialog box without recalling the monitor list file, select Cancel.
Figure 6.4 – Recall Monitor List Dialog Box