Rockwell Automation Liqui-Flo Control Configuration Software Version 6.0, M/N 2CS3000 User Manual
Page 69
Controlling the Drive
8-3
You can also access other CS3000 software functions while the Drive Control window
is on the screen. The Drive Control window remains open until you close the window
(by selecting the Close button) or exit the CS3000 software.
The following sections describe how to use the Drive Control window to control a
drive’s functions.
Important: If a running drive that is being controlled by the CS3000 software loses
communication with the software, a serial fault occurs and the drive stops.
If the running drive is being controlled by its front-panel and
communication with the software is lost, the message “Disconnected”
appears in the main window, and the drive status window displays “Not
Connected.”
Figure 8.1 – Drive Control Window