Rockwell Automation Liqui-Flo Control Configuration Software Version 6.0, M/N 2CS3000 - Manual (Page 95)

Index Index-1
I
NDEX
A
About the Control and Configuration Software, 1-1
cables, 1-1
exiting the software, 2-10
hardware requirements, 1-2
intended audience, 1-3
menus, 2-7
overview, 1-1
purpose of this manual, 1-3
safety information, 1-3
software requirements, 1-1
starting the software, 2-5 to 2-7
terms used in this manual, 1-4
toolbars, 2-8 to 2-10
where to find additional information, 1-4
Additional information, 1-4
Audience, 1-3
Auto Scale, 9-5
ASCII, 9-11
C
Cables, 1-2
Communication, set up
connecting the serial port, 2-3 to 2-5
selecting the communication port, 2-5
selecting the drive, 2-5
Configuring the Drive, 3-1
comparing the drive configuration to the
opened configuration, 4-5
comparing the parameter values in the opened
configuration with those in another con-
figuration file, 4-4 to 4-5
creating a new configuration, 3-2
downloading a drive configuration, 4-2
editing a configuration, 3-7 to 3-10
assigning parameter values, 3-7 to 3-9
ending an editing session, 3-9
entering and editing a configuration de-
scription, 3-9 to 3-10
icons, 2-9
opening a drive configuration file, 3-3 to 3-4
different version of same drive, 3-5 to 3-6
printing a configuration, 3-12
saving a drive configuration, 3-12
saving the open drive configuration to another
file, 3-11
selecting a drive, 3-1
uploading a drive configuration, 4-1
Controlling the Drive
connecting a drive, 8-1
controlling a drive, 8-2 to 8-3
disconnecting a drive, 8-1
icons, 2-10
monitoring drive indicators, 8-6
selecting the,
control source, 8-4
direction of motor rotation, 8-4
reference mode, 8-4
setting the,
drive reference, 8-4
jog reference, 8-5
starting and stopping the drive, 8-5
Cursors, 9-8
D
Description
configuration, 3-9
Drive Parameters
adding to monitor list, 6-3
assigning values, 6-4 to 6-6
clearing monitor display, 6-8
displaying a monitor list, 6-7
exiting the monitor, 6-8
overview, 6-1 to 6-2
removing from monitor list, 6-3
saving a monitor list, 6-6
E
Editing
a configuration, 3-7 to 3-10
assigning parameter values, 3-7 to 3-9
configuration description, 3-9 to 3-10
ending an editing session, 3-9
drive parameters, 6-4 to 6-6
assigning values, 6-4 to 6-6
clearing monitor, 6-8
removing, 6-3