Rockwell Automation Liqui-Flo Control Configuration Software Version 6.0, M/N 2CS3000 - Manual (Page 40)

4-4 Control and Configuration Software V6.1
4.4 Comparing the Parameter Values in the Opened
Configuration with Those in Another Configuration
File
You can compare the parameter values in the opened configuration with those
parameter values in another configuration file. To do this:
Step 1. Make sure the configuration file to be compared is opened.
Step 2. From the Config menu, choose Compare File.
The Compare Configuration dialog box is displayed as shown in Figure 4.1.
Step 3. Use the dialog box to specify the file that you want to compare with the
opened configuration file. Use the Network button to access network drives.
Step 4. Begin the comparison by clicking OK.
Figure 4.1 – Compare Configuration File Dialog Box