Rockwell Automation FactoryTalk Historian SE 3.0 UniInt Interface User Guide User Manual
Uniint interface user manual
Advertising
Table of contents
Document Outline
- Introduction
- Interface Startup Parameters
- Historian Point Configuration
- What are Historian Points?
- Interface Points
- Point Attributes
- Historian Tag String Attribute Limits
- Input Points
- Output Points
- I/O Rate Points
- Performance Points
- Performance Summaries
- UniInt and PI SDK
- “Known Servers” Table
- Interface Operation
- Windows Performance Counters
- Interface Health Points
- Extended Descriptor Requirements
- Interface Disconnected Startup
- Disconnected Startup Requirements
- Point Synchronization and Historian Server Connections
- Point Modifications on the Historian Server and Interface Restarts
- Limitations
- Startup Command File Configuration
- ICU Configuration
- Disconnected Startup Architecture
- Operation
- Remote Cache Builds
- Messages
- Troubleshooting
- UniInt Failover Scheme
- Introduction
- Configuring UniInt Failover
- Steady State Operation
- Glossary
- Input Data
- Failover Scenarios
- Error and Informational Messages