Rockwell Automation FactoryTalk Historian SE 3.0 UniInt Interface User Guide - Manual (Page 61)

UniInt Interface User Manual 55
Sample Interface Startup Files
The following is an example of an interface configured for Disconnected Startup. In this
example, the interface name is ifc and the interface executable is ifc.exe. Any additional
command-line parameters needed for the interface would be defined on the startup
command-line file. The startup command file for the interface would be defined as follows:
ifc.exe /PS=E /ID=1 /CacheMode /CacheSynch=100 /host=PISrv:5450 ^
other parameters as required
ICU Configuration
The use of the ICU is the recommended and safest method for configuring the Interface for
Disconnected Startup. With the exception of the notes described in this section, the Interface
shall be configured with the ICU as described in the ―Configuring the Interface with the
ICU‖ section of this manual. The rest of this section refers to the latest version of the ICU
1.4.1.x or later which requires SDK 1.3.4.333 or greater to use the ICU to configure
disconnected startup. The following figure shows the Disconnected Startup configuration
screen of the ICU.