6 - system commissioning, Before you begin, What you need – Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start User Manual
Page 195: Chapter 6, System, Commissioning, System commissioning, Before you begin what you need, For configuring your, Chapter
Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012
195
Chapter
6
System Commissioning
In this chapter you download your Logix and PanelView Plus applications, prepare and tune your drive hardware,
verify network communication, and verify general operator/program control.
Before You Begin
•
Complete your system architecture and hardware selection (refer to
).
•
Complete your system layout and wiring (refer to
•
Complete your FANUC CNC Configuration (refer to
).
•
Complete your logic configuration (refer to
).
•
Complete your FactoryTalk View Machine Edition configuration (refer to
).
What You Need
•
The CNC Machining Accelerator Toolkit DVD, publication
. For a copy of the DVD,
contact your local Rockwell Automation distributor or sales representative.
•
RSLogix 5000 software, version 20.0 or later.
•
RSLinx Classic software, version 2.56 or later.
•
FactoryTalk View Studio software, version 6.0 or later.
•
FANUC LADDER III software, version 6.8 or later, and the publications listed here:
–
FANUC Series 30i/31i/32i/35i –MODEL B, EtherNet/IP Adapter function, publication
[email protected].
–
FANUC Series 30i/31i/32i/35i -MODEL B, FANUC Power Motion i -MODEL A EtherNet/IP
Scanner function, publication [email protected].