Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start User Manual
Page 89
Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012
89
GuardLogix Configuration
Chapter 4
Configure Ethernet Module for your HMI Terminal and CNC Modules
1.
Expand I/O Configuration in the Controller
Organizer.
2.
Right-click I/O Configuration and choose New
Module.
The Select Module Type dialog box opens.
3.
Expand the Communications
category and select your 1756-series
Ethernet module.
In this example, the 1756-EN2TR
module is selected.
4.
Click Create.
The New Module dialog box opens.
5.
Configure the new module.
a. Enter the module Name.
b. Enter the Logix EtherNet/IP
module slot (leftmost slot = 0).
c. Select an Ethernet Address option.
In this example, the Private Network
address is selected.
d. Enter the address of your
EtherNet/IP module.
In this example, the last octet of the
address is 10.
6.
Click Change in the Module
Definition area.
The Module Definition dialog box opens.
TIP
For systems communicating to a
FANUC CNC over an EtherNet/IP
network, a 1756-EN2x or
1756-EN3x module is required.