Rockwell Automation 1756-EN2TSC EtherNet/IP Secure Communication User Manual - Manual (Page 20)

20 Rockwell Automation Publication ENET-UM003B-EN-P - August 2013
Chapter 2 Get Started
In This Field Specify
Ethernet Interface Configuration The network configuration scheme:
• Dynamic BOOTP (default)
• Dynamic DHCP
• Static
IP Address IP address for the module:
If you want to specify a static IP address for the module, you must also choose Static for the Ethernet Interface
Configuration field.
Subnet Mask Subnet mask for the module.
Default Gateway Gateway address for the module.
Primary Server Name
Secondary Server Name DNS server addresses, if you are using DNS addressing within your Logix program.
Domain Name Domain name for the web server module, if you are using DNS addressing within your Logix program.
Host Name Host name for the module.
Name Resolution (DNS) Whether the module uses DNS addressing within your Logix program.
Autonegotiate Status How to determine port speed and duplex:
• Autonegotiate speed and duplex (recommended)
• Force speed and duplex
Select Port Speed Port speed (10 Mbps or 100 Mbps), if you chose to force speed and duplex.
Select Duplex Mode Duplex (full or half), if you chose to force speed and duplex.