Rockwell Automation 1756-EN2TSC EtherNet/IP Secure Communication User Manual - Manual (Page 34)

34 Rockwell Automation Publication ENET-UM003B-EN-P - September 2013
Chapter 3 Configure a Secure Connection to a Microsoft Windows Client
15. Click Add.
Configure a Connection to a
Microsoft Windows Client An IPsec client is required to make a secure connection to the module. Without
an active IPsec association, the module drops packets, which appear as message
timeouts. The IPsec client comes pre-installed in the Windows 7 operating
system.
To configure a Microsoft Windows client, do the following.
1. From the Control Panel, open the Network and Sharing Center.
2. Click Setup a new connection or network.
3. Select Connect to a workplace and click Next.