Rockwell Automation Logix5000 Control Systems: Connect ArmorBlock I/O Modules over Ethernet Quick Start - Manual (Page 10)

10 Rockwell Automation Publication IASIMP-QS039A-EN-P - July 2013
Chapter 1
Mount the Module
Two holes are used to mount the module directly to a
panel or machine. Mounting holes accommodate #6
(M3) pan-head screws. The torque specification is 0.68
N•m (6 lb•in).
To mount the module on a wall or panel, use the screw
holes provided in the module. Refer to the drilling
dimensions illustration to guide you in mounting the
module.
Mounting Dimensions
Install the mounting base as follows.
1. Lay out the required points as shown.
2. Drill the necessary holes for #6 (M3) pan-head
screws.
3. Mount the module by using #6 (M3) screws.
High Vibration Area Mounting
If you mount the module in an area that is subject to shock or vibration, we recommend that you use a flat washer and lock
washer as shown. Torque the mounting screws to 0.68 N•m (6 lb•in).
LINK 1
MOD
7
6
5
4
3
2
1
0
P
W
R
X100 X1
X10
8
9
10
11
12
13
14
15
NET
LINK 2
65.0
(2.56)
179.0
(7.05)
169.0
(6.65)
26.5
(1.04)
43.3
(1.70)
Dimensions are in millimeters (inches)
Lock Washer
Flat Washer