Rockwell Automation Logix5000 Control Systems: Connect ArmorBlock I/O Modules over Ethernet Quick Start - Manual (Page 3)

Rockwell Automation Publication IASIMP-QS039A-EN-P - July 2013 3
Where to Start
This quick start provides examples and procedures for including 1732E ArmorBlock® EtherNet/IP modules in a
Logix5000™ control system over an EtherNet/IP network. The figure below describes the tasks you must complete.
RUN REM PROG OK RS232 I/O
BAT
RUN Logix5565
1756-EN2T
EtherNet/IP
Logix5565
LINK 1 MOD
7
6 5
4 3
2 1
0
P
W
R
X100 X1
X10
8
9 10
11 12
13 14
15
NET LINK 2
Chapter 1
Install Your ArmorBlock I/O Module
Prerequisite Tasks
Prepare the 1732E ArmorBlock
EtherNet/ IP Module Hardware.
Add the 1732E ArmorBlock
EtherNet/ IP Module
Hardware to an RSLogix™
5000 Project.
Chapter 2
Use RSLogix 5000 Software to Configure the Module
Chapter 3
Embedded Web Server Introduction
Become familiar with the
embedded web server.