Rockwell Automation Logix5000 Control Systems: Connect ArmorBlock I/O Modules over Ethernet Quick Start - Manual (Page 17)

Rockwell Automation Publication IASIMP-QS039A-EN-P - July 2013 17
Chapter 2
3. Select the 1756-EN2T EtherNet/IP bridge and click OK.
The New Module dialog box opens.
4. Configure the module.
a. Name the bridge.
b. Enter the IP address.
c. Select slot 3 for the EtherNet/IP bridge.
d. Make sure the Minor Revision number matches your module revision number.
e. Choose an Electronic Keying method.
f. Click OK.
5. Add the I/O module as a child of the 1756-EN2T module.
The New Module dialog box opens.