Rockwell Automation Logix5000 Control Systems: Connect ArmorBlock I/O Modules over Ethernet Quick Start - Manual (Page 24)

24 Rockwell Automation Publication IASIMP-QS039A-EN-P - July 2013
Chapter 2
Test the 1732E-OB16M12R Output Module’s Light
1. Move the controller’s mode switch to the RUN position.
2. Open the Main Routine of the project to find the ladder logic written earlier.
3. Select the PB and press Ctrl+T.
This toggles the state from 0 to 1 (off to on).
4. Verify that the light on the distributed output module turns on.
5. Press Ctrl+T to toggle the state 1 back to 0 (off ).
6. Choose Go Offline.