Rockwell Automation FlexPak 3000 Drive Field Current Regulator Kit, 911FK0041, 911FK0101, 911FK015 - Manual (Page 13)

Installing the Field Current Regulator Kit on 1.5 - 30 HP @ 230 VAC and 3 - 60 HP @ 460 VAC Drives 2-1
C
HAPTER
2
Installing the Field Current Regulator Kit
on 1.5 - 30 HP @ 230 VAC and
3 - 60 HP @ 460 VAC Drives
Installing the Field Current Regulator kit on 3 - 60 HP drives requires completing the
following steps. When you have finished installing the kit, adjust the required drive
parameters as described in chapter 5 before using the drive.
• Opening the cover and carrier
• Removing the Standard or Enhanced Field Supply board
• Installing the Field Current Regulator board
• Wiring the Field Current Regulator board
• Replacing the drive fuses
• Reinstalling the drive carrier and cover
• Modifying the drive configuration
These steps are described in the following sections.
!
ATTENTION: Only qualified personnel familiar with the construction and
operation of this equipment and the hazards involved should install,
adjust, operate, and/or service this equipment. Read and understand
this instruction manual in its entirety before proceeding. Failure to
observe this precaution could result in severe bodily injury or loss of life.
ATTENTION: The drive is at line voltage when connected to incoming
ac power. Disconnect, tag, and lockout all incoming power to the drive
before performing the following procedure. Failure to observe this
precaution could result in severe bodily injury or loss of life.