Rockwell Automation FlexPak 3000 Drive Field Current Regulator Kit, 911FK0041, 911FK0101, 911FK015 - Manual (Page 22)

3-4 FlexPak 3000 Field Current Regulator Installation Instructions
3.6 Reinstalling the Auxiliary Chassis Cover, Carrier and
Drive Cover
Step 1. Insert the tabs on the left side of the auxiliary chassis cover into the slots on
the right side of the drive’s motor terminal panel.
Step 2. Align the auxiliary chassis cover over the middle screw on the drive’s right
side panel and over the top and bottom mounting holes.
Step 3. Insert the top and bottom screws into the mounting screw holes and then
tighten all three mounting screws (top, bottom, and middle).
Step 4. Tighten the two screws on the right side of the motor terminal panel to secure
the auxiliary chassis cover’s tabs in place.
Step 5. Drives with an AC line disconnect only: Align the AC line disconnect over
the mounting holes on the auxiliary chassis cover, then secure it in place with
the four screws removed earlier.
Step 6. Close the OIM carrier and secure it in place with its captive screw.
Step 7. Reinstall the drive cover and secure it in place with its screws. Hardware
installation is complete.
Step 8. Reconnect power to the drive.
Step 9. Remove the lockout and tag.
Step 10. Turn on power to the drive.
3.7 Modifying the Drive Configuration
Go to chapter 5 for information on setting parameters for the Field Current Regulator
kit.