Rockwell Automation FlexPak 3000 Drive Field Current Regulator Kit, 911FK0041, 911FK0101, 911FK015 - Manual (Page 25)

Installing the Field Current Regulator Kit on 100 - 150 HP @ 230 VAC and 200 - 300 HP @ 460 VAC Drives 4-1
C
HAPTER
4
Installing the Field Current Regulator Kit
on 100 - 150 HP @ 230 VAC and
200 - 300 HP @ 460 VAC Drives
Installing the Field Current Regulator kit on 200-300 HP drives requires completing
the following steps. When you have finished installing the kit, adjust the required drive
parameters as described in chapter 5 before using the drive.
• Opening the cover and carrier
• Removing the Enhanced Field Supply board
• Installing the Field Current Regulator board
• Wiring the Field Current Regulator board
• Replacing the drive fuses
• Reinstalling the drive carrier and cover
• Modifying the drive configuration
These steps are described in detail below.
!
ATTENTION: Only qualified personnel familiar with the construction and
operation of this equipment and the hazards involved should install,
adjust, operate, and/or service this equipment. Read and understand
this instruction manual in its entirety before proceeding. Failure to
observe this precaution could result in severe bodily injury or loss of life.
ATTENTION: The drive is at line voltage when connected to incoming
ac power. Disconnect, tag, and lockout all incoming power to the drive
before performing the following procedure. Failure to observe this
precaution could result in severe bodily injury or loss of life.