AJA KONA LHi - Manual (Page 57)

KONA v10.5 www.aja.com 57
HDMI Output Settings The Source pulldown menu allows you to select either the primary video format
(framebuffer) or a secondary one (up/down/cross-conversion).
Stereo 3D: A pulldown menu for 3D output allows you to select either Side-by-Side or Top-Bottom
(Stacked) output of left-eye and right-eye signals.
NOTE: This selection must agree with format selection in the third-party CineForm Codec (NOT
included with AJA KONA 4/3G) pulldown menu.
Pulldowns are also provided for configuring the video Protocol, Color Space, RGB Range,
and Audio Channels:
Protocol: The Protocol pulldown allows you to choose either “HDMI” or “DVI” protocol—use DVI if
you’re outputting to a DVI monitor using an HDMI to DVI adapter.
Color Space: Selects the HDMI output color space and depth. These are the choices:
• Auto–UDC automatically selects the mode based on getting the attached HDMI
device's EDID information. This is the recommended setting. The selected mode is
shown to the right of the pull-down control.
• RGB 8Bit–UDC uses 8-bit RGB mode regardless of the attached device's EDID.
• RGB 10Bit–UDC uses 10-bit RGB mode regardless of the attached device's EDID.
• YCbCr 10Bit–UDC uses 10-bit YCbCr mode regardless of the attached device's
EDID.
RGB Range (SMPTE or Full levels)–the RGB Range pulldown menu allows you to
select either Full range (0-1023) or SMPTE range (typically 64-940) for RGB color
output.
Audio Channels–an Audio Channel pulldown allows you to select the number of
embedded audio channels for the HDMI output.
KONA LHi HDMI Input
Settings
The detected HDMI input video format is displayed and you’re given pull-down menus to
configure the RGB range (SMPTE or FULL) and select any two embedded channel pairs
from those supplied for stereo output (if applicable).
Figure 49. KONA LHi Input Screen section