Baumfolder Flexifold: Pile Folder (in 2004) - Manual (Page 31)

PAGE 31 TP10496
10.0 PRODUCTION RUN MODE
To initiate production, operate the Feeder ON and load the feeder.
1. Lower the table using the Table Down Key, 8.
Note: If the Table Down Key is pressed twice within 0.5 seconds, the table will
proceed past the ergonomic pile reload height position and continue until it trips the
lower limit switch.
2. Load the Table and raise the Table by holding down the Table Up Key, 10.
3. Start the drive on the 1st Folding Station.
4. Start the Pump on the 1st Folding Station and adjust the air blow on the Pile Feeder.
5. To assist the setup of the 1st Station Folder for proper folding, the Feeder should be set to
single sheet mode. To initiate the Single Sheet Mode on the Feeder, press the Sheet Mode Key,
3. The message
is displayed. Single Sheet Mode will make the Feeder feed a single sheet each time the
Sheet Start Key, 4, is depressed. Once the 1st Station Folding, Register, and Pile Feeder have
been properly adjusted to the desired settings, exit Single Sheet Mode by pressing the Sheet
Mode Key. This will place the Pile Feeder into production mode and the Pile Feeder will have
the Count Screen displayed.
6. To start the Machine in production mode, press the Sheet Start Key, 4.
7. The sheet gap may be changed by varying the speed of the Feeder. The speed can be changed
while running product. To enter into the sheet gap adjust feature, press the Sheet Gap Key,
15. The Sheet Gap screen should now be displayed. To adjust the sheet gap, press the Up/
Down Arrow Keys, 14/13. Once the desired sheet gap has been achieved, then press the Enter
Key, 7.
11.0 BATCH RUN MODE SETUP
The following steps will instruct you on how to setup the Pile Feeder for running batches.
1. Press the Batch Set Key, 11. The Batch Set screen will be displayed.
The Z digits (flashing) are the batch size. Use the Up/Down keys, 14/13, to set the desired
Batch Size.
2. Press the Enter key, 7, to enter the data into memory and switch to the Interrupt Timing
setting.
3. The Y digits (flashing) are the Feed Interrupt Time measured in seconds. Use the Up/Down
keys, 14/13, to set the desired Interrupt Time.
4. Press Enter key, 7, to enter the data into memory and switch to the Count Screen.
- The X digits represent the Total Count since the last reset.
- The Z digits represent the Number of Batches completed.
- The W digits represent the Number of Sheets remaining to complete the next batch (Batch
Count).