Baumfolder Flexifold: Pile Folder (in 2004) - Manual (Page 34)

TP10496 PAGE 34
16.0 RUN FAULT ERROR MESSAGES
These error messages may occur during setup or a production run.
17.0 CONTROLLER LED LIST
The following is a list of LEDs and their associated circuit located on the controller.
18.0 DIAGNOSTIC PROGRAM
The diagnostic program contains several routines that will test the operator keypad, test the
controller sensors, test the controller output circuits and test the panel indicators.
18.0.1 PILE FEEDER KEYPAD SWITCH TESTS
This test will provide a way of checking the operation of the switches on the operator keypad.
During this test, all outputs from the motors, sensors, etc. are turned off. Also, you may exit this
diagnostic program at any time by pressing the Diagnostic Key, 5.