Baumfolder Flexifold: Pile Folder (in 2004) - Manual (Page 35)

PAGE 35 TP10496
1. Turn the main Pile Feeder Power Switch on.
2. Press the Pile Feeder Start Key, 2.
3. Press the Diagnostic Key, 5. The message
will be displayed.
4. Press the Enter Key, 7, to enter the diagnostic tests or press the Reset Key, 5, to exit. The
message
5. Press the Enter Key, 7, to enter the keyboard tests. The message
will be displayed if Enter Key is pressed.
6. Press the Table Up Key, 10, and the display should switch between to “ACTIVE” each time
the Table Up Key is pressed. If the display shows that the Table Up Key is still inactive while the switch
is pressed, then there is a problem with the display assembly, communication cable or controller board.
8. Select each Keypad Key by using the Up/Down Arrow Keys, 14/13, and test each
corresponding Keypad Key. As each key is operated, the status should switch between “INACTIVE”
and “ACTIVE”. The table below shows what each Keypad Key’s normal and operated state should be.