Baumfolder Flexifold: Pile Folder (in 2004) User Manual
Page 33
PAGE 33
TP10496
14.0 RESETTING THE TOTAL COUNTER
The following instructions will allow you to reset the Total Counter.
Note: The Batch Counter will also be reset to zero, 0, when the Total Counter is reset.
1. Press the Reset Key, 5, and the Reset Screen
will be displayed.
2. Press the Count Key, 12, and the display will return to the Batch Count Screen with the Batch
Counter and the Total Counter reset to zero, 0.
15.0 POWER UP FAULT ERROR MESSAGES
When power is applied to the Feeder Controller, a power up routine is automatically initiated.
During this a message
is displayed. During this Power up routine, various aspects of the controller are checked. The Power
up routine can generate error messages depending on the fault detected. The following Error messages
table lists the messages that can be generated and a possible solution to the problem. The errors must
be corrected before the feeder will become operational. If no errors are detected, the “PLEASE WAIT”
screen will disappear, and a message
will appear for a few seconds. Press Pile Feeder Start Key, 2. This will allow the Pile Feeder to go into
production mode and the display will show the main count screen.