Metrohm 761 SD Compact IC User Manual
761 sd compact ic, 1043 instructions for use
Advertising
Table of contents
Document Outline
- 761 SD Compact IC
- Table of contents
- 1 Introduction
- 2 Installation
- 2.1 Flow chart
- 2.2 Setting up the instrument
- 2.3 Description of the connections
- 2.4 Connection of the detector block
- 2.5 Installation of the MPak cabinet and connection of the drain tubes
- 2.6 Installing the eluent path
- 2.6.1 High-pressure pump – Removing the transport security screws
- 2.6.2 Connection MPak – high-pressure pump
- 2.6.3 Connection high-pressure pump – injection valve
- 2.6.4 Connection injection valve – suppressor
- 2.6.5 Connection suppressor – detector
- 2.6.6 Connection detector – waste
- 2.6.7 Connection suppressor – waste
- 2.7 Installing the regenerant path
- 2.8 Installing the sample path
- 2.9 Connecting the 766 IC Sample Processor
- 2.10 Fitting the rear panel
- 2.11 Mains connections
- 2.12 Connection to the PC
- 2.13 Deaerating the pump and rinsing the pulsation dampener
- 2.14 Rinsing before fitting the column
- 2.15 Precolumn and separating column
- 2.16 Attaching tubing to side panels
- 3 «IC Net»
- 4 «IC Cap»
- 5 Operation
- 6 Notes – Maintenance – Faults
- 7 Appendix
- 7.1 Technical data
- 7.1.1 Conductivity measurement
- 7.1.2 Conductivity detector
- 7.1.3 Injection valve
- 7.1.4 High-pressure pump
- 7.1.5 Peristaltic pump
- 7.1.6 Suppressor module
- 7.1.7 Leak detector
- 7.1.8 RS232 interface
- 7.1.9 Remote interface
- 7.1.10 Mains connection
- 7.1.11 Safety specifications
- 7.1.12 Electromagnetic compatibility (EMC)
- 7.1.13 Ambient temperature
- 7.1.14 Housing
- 7.2 Standard equipment
- 7.3 Optional accessories
- 7.4 Warranty and conformity
- 7.5 Index
- 7.1 Technical data