Metrohm 844 UV/VIS Compact IC - Manual (Page 76)

Table of contents
Pump pressure, MPa Displays the currently measured pressure of the
high-pressure pump (units depend on the
settings made under IC NET / Global
preferences ).
Valve Live display of the position of the injection
valve.
Remote lines Live display of the status of the 8 remote lines.
Column temp., °C Live display of the temperature in the column
oven.
Controls
On the subtab Controls injection valve 46/60., peristaltic pump 49, high-
pressure pump 27/54, column heating 115 and remote lines can be
manually controlled. In addition, the parameters for the high-pressure
pump and column heating temperature can also be set:
Valve Injection valve
<Inject> Switch injection valve to "Inject" position.
<Fill> Switch injection valve to "Fill" position.
Peristaltic pump Peristaltic pump
<On> Start peristaltic pump (only enabled, with
versions 2.844.0020 or 2.844.120).
<Off> Stop peristaltic pump (only enabled, with
versions 2.844.0020 or 2.844.120).
IC pump High pressure pump
<On> Start high pressure pump.
<Off> Stop high pressure pump.
Flow, mL/min Set value for flow rate of IC pump.
Entry range: 0.20 ... 2.50 mL/min