Banner VALU-BEAM Series - Manual

VALU-BEAM 915 Series Sensors
With Electromechanical Relay Output
Printed in USA P/N 03453L9E
VALU-BEAM 915 Series Features
• Models available for:
- 12 to 28V ac/dc
- 90 to 130V ac
- 210 to 250V ac
• SPDT electromechanical relay output is rated for up to 5 amps switching capacity
• Rear panel sensitivity adjustment; top-mounted alignment indicator
• Visible red beam on most models, simplifies alignment
• Choose models with integral 2 m (6.5') cable or Mini-style QD (quick-disconnect)
connector; 9 m (30') cables are also available
Infrared, 880 nm
915 Series Opposed-Mode Emitter (E) and Receiver (R)
SMA91E
SMA95R
SMA91EQD
SMA95RQD
Emitter:
10 to 250V
ac/dc
Receiver:
90 to 130V ac
2 m (6.5')
2 m (6.5')
3-Pin Mini QD
5-Pin Mini QD
Models Range Cable*
Supply
Voltage
Output
Type Excess Gain Beam Pattern
SMA91E
SMW95R
SMA91EQD
SMW95RQD
60 m
(200')
2 m (6.5')
2 m (6.5')
3-Pin Mini QD
5-Pin Mini QD
Emitter:
10 to 250V
ac/dc
Receiver:
12 to 28V
ac/dc
SPDT
E/m
Relay
1
10
100
1.0 m
3.3 ft
10 m
33 ft
100 m
330 ft
0.1 m
0.33 ft
E
X
C
E
S
S
G
A
I
N
DISTANCE
1000
Opposed Mode
SMA91E &
SMW95R or
SMA95R or
SMB95R
75 m
250ft 60 m
200 ft
45 m
150 ft
30 m
100 ft
15 m
50 ft
0
0
500 mm
1000 mm
1500 mm
500 mm
1000 mm
1500 mm
0
20.0 in
40.0 in
60.0 in
20.0 in
40.0 in
60.0 in
DISTANCE
SMA91E with SMW95R
or SMA95R or SMB95R
Opposed Mode
SMA91E
SMB95R
SMA91EQD
SMB95RQD 2 m (6.5')
2 m (6.5')
3-Pin Mini QD
5-Pin Mini QD
Emitter:
10 to 250V
ac/dc
Receiver:
210 to 250V ac
Effective Beam: 13 mm
*NOTES:
• 9 m (30') cables are available by adding suffix “W/30” to the model number of any cabled sensor (e.g. SMA91E W/30).
• A model with a QD connector requires an accessory mating cable. See page 8 for more information.
Opposed-mode sensors have higher excess gain than other models, and so should be
used whenever possible. Visible red “tracer beam” simplifies sensor alignment.