Tweco PAK 200i - Manual (Page 50)

PAK 200i
4-1� OPERATION Manual 0-5335
CCM Status Code
Group 6 -- CCM
Code Message Remedy / Comments
601 Analog Voltage Error Defective CCM, replace.
602 ADC or DAC error Defective CCM, replace.
603 Reserved No information available; Contact customer service
604 Data Memory error Defective CCM, replace.
605 Program memory fault Defective CCM, replace.
606 +5V Logic supply low Defective CCM, replace.
607
Processor over tem-
perature
Reduce ambient temperature; Defective CCM; replace
608
5V supply for RS
485/422 communica-
tion low.
Defective CCM, replace.
609
Firmware Update
Device Error
Defective CCM; replace
610
Firmware Update
Protocol Error
Defective CCM; replace
611 USB Controller Fault Defective CCM; replace
612 USB Power Fault Remove faulty USB device; Defective CCM
613 USB Log Creation Fault Unable to create Log file on USB Flash drive last firmware update attempt; Use different USB
Flash Drive or Reformat
614 No USF File
File VTCCMFW.USF missing from Flash Drive; Add proper files to Flash Drive for Firmware
Update; Use different USB Flash Drive or Reformat
615 No CCM Update File
CCM Firmware file specified in VTCCMFW.USF not found ; Add proper files to Flash Drive for
Firmware updating
616 DPC Update Fault
Fault occurred attempting to update DPC firmware; Add proper files to USB Flash drive for
Firmware updating; Refer to CCM_LOG.TXT on Flash Drive for details
617 DMC Update Fault
Fault occurred attempting to update DMC firmware; Add proper files to USB Flash drive for
Firmware updating; Refer to CCM_LOG.TXT on Flash Drive for details
618 ADC Calibration Fault Error too large calibrating ADC; Fault persists defective CCM;
619 Flow Switch Fault Flow switch reporting coolant flow when pump off;
620
Non Volatile Memory
Error
Non Volatile Memory Storage Corrupted and Erased; Fault persists defective CCM.
621 USB Format Fault
A USB flash drive was detected but could not be read by CCM. Backup any files currently on
flash drive, reformat the USB flash drive to a FAT or FAT32 file system, replace only the CCM
update files and try again. Use different USB flash drive formatted with FAT or FAT32 file
system.
622
CCM Code Execution
Fault
Possible EMI noise problem or code fault. Check for proper grounding and bonding of
equipment and routing of torch leads and cables to reduce Electromagnetic Emission
Interference onto CCM module. If problem persists, verify CCM code version is the latest
supported revision. Replace CCM module.