Profile series v.g1 cylindrical lock, Remove outside lever only, How to change cylinder (if required) – SARGENT Profile Series v.G1.5 Cylindrical Locks User Manual
Page 9: Securing the lock to door
7
800-810-WIRE (9473) • www.sargentlock.com • A7755A
Profile Series v.G1 Cylindrical Lock
Copyright © 2004, 2008, Sargent Manufacturing Company
, an A
SSA ABL
O
Y
Group company
. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
1. Insert key, rotate 45° clockwise and hold
2. Depress lever retainer with push pin tool (provided).
7. Remove Outside Lever Only
1. With outside lever in hand- use standard
pliers, pull out cylinder retainer.
2. Remove key and cylinder from lever.
3. Insert new cylinder.*
4. Secure by pressing cylinder retainer
flush with self.*
* NOT SHOWN
How to Change Cylinder
(if required)
45º
Feed wires and
connector in
routed channel
Routed channel for
wood door only
Screws
partially
tightened
1A. If wood door, feed wires up through the
routed channel as shown.
1B. If metal door, feed wire and connector
through inside of door and out hole on
outside of door. *
2.
Attach inside rose assembly and
spacer bushing and secure with
screws shown
6. Securing the Lock to Door
Washers
(only 30- prefix)
Cylinder
Retainer
Cylinder
Outside
Lever
Key