SARGENT Profile Series v.S1 PoE Cylindrical Lock User Manual
Page 2
A8094A 2
12/14/10
Copyright © 2009 Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
FOR INSTALLATION ASSISTANCE CONTACT SARGENT • 1-800-810-WIRE (9473) • www.sargentlock.com
S1/S2 Replacement Controller Instructions
52-4424, 52-4425, 52-4426
8.
Reconnect the keypad harness, ground wire, DPS
harness, motor harness, and hard-wired/PoE harness
(if present).
9.
Mount the inside escutcheon back on the door using the
two through-bolt screws. Reattach lever (if applicable).
10.
Install batteries and battery keeper (if applicable).
11.
Using Lock Configuration Tool (LCT), connect to the
new controller.
12.
From the main drop down, select “Configure Serial
Number”.
13.
Select “Configure Serial Number in LCT” and click Go.
14.
Select the correct reader/human interface.
15.
Select the correct lock body
.
16.
Click Apply Serial Number (S/N).
17.
Configure lock as usual.
Note: The serial number should match the serial
number on the previous controller which can either
be found on the controller or through the connected
EAC system.
18.
Replace battery cover and install security screw.