SARGENT DL Series Tubular Lock - Manual (Page 3)

3
Copyright © 2008, 2009, 2012, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written permission of
Sargent Manufacturing Company is prohibited.
A7858E 07-19-12
Parts List Description:
1. Square mounting plate
2. #6 x ¾" Machine Screws (2)
3. Rose
4. Lever (2)
5. Set Screw (2)
Tools Needed:
1. Drill
2. Pilot bit
3. Phillips screw driver
4. Right angle square
1. Install lock per instructions on page 2
a. Square rose installation begins after spring housing installation
2. Position square mounting plate over spring housing as seen in Figure 1
3. Drill two centered pilot holes for the #6 mounting screws in the upper right and lower
left portions of the square mounting plate
4. Loosely attach mounting plate to both sides of the door with screws
5. Square top surface of mounting plate to edge of door
a.
NOTE: The right angled square MUST be on the flat surface of the square
mounting plate for proper leveling
6. Tighten mounting screws
7. Press rose onto mounting plate, fasten lever with set screw
Square Rose Installation
1
1
2
3
4
5
Figure 1
Scan to see a
video of this
installation step.