SARGENT GX Series (3 Line) User Manual
Page 2
MARK & DRILL HOLES
DISASSEMBLE LEVER FROM LOCK
INSTALL LOCK MOUNTING PLATE
REPLACE LEVER
1
2
3
4
a) Mark a horizontal line on the face of the door at the height where the lock is to be installed. 38"
(956mm) from finished floor is recommended.
b) Place the cutout template as shown and mark the centers of the 3 screw positions.
Drill three, 1/8" (3mm) diameter by 3/8" (9mm) deep guide holes where marked.
MARQUE Y HAGA LOS AGUJEROS
a) Marque una lìnea horizontal en la hoja de la puerta a la altura que desee instalar la cerradura,
sugerimos 38” (965 mm) del piso.
b) Coloque la plantilla en la forma que indica la figura y marque el centro de los tres cìrculos. Haga los
barrenos guìa con una broca de 1/8” (3 mm), con una penetraciòn aproximada de 3/8” (9 mm).
a) Remove lever by depressing lever catch on side of lever body.
b) Separate rose from mounting plate by prying apart with flat screwdriver at notch.
DESMARME LA CERRADURA
a) Desmonte la manija con una “punta” ò desarmador plano oprimiendo la cuña alojada en la
ranura de la manija.
b) Retire la roseta haciendo palanca en su ranura auxiliandose del desarmador plano.
a) Orient the mounting plate and fasten it with three screws.
b) Replace rose, verifying that its’ notch lines up with the spring catch and lateral groove
in the mounting plate. Press firmly to attach.
INSTALE LA CERRADURA
a) Oriente la placa de montaje y fìjela con tres tornillos.
b) Coloque la roseta verificando que la muesca de ésta coincida con la ranura lateral
del plato y presione.
Place lever on spindle and push on.
Verify that lever catch snaps into lever.
COLOQUE LA MANIHJA
Coloque la manija en el poste y empujela verificando que
la cuña del poste entre en la ranura de la manuja.
38" (956mm)
Finish floor
a
b
a
b
a
b
Spring catch
Lever catch
A7591A
Copyright © 2009, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part
without the express written permission of Sargent Manufacturing Company is prohibited.