SARGENT 1655 Locker Lock - Manual

Be sure set screw is not
exposed after assembly
to door
FOR ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com
Installation
Insert locker lock into prepared door and secure with 4 screws provided.
For doors between 1" and 1-1/2" thick use spacers provided to conceal cylinder retaining set screw.
Secure strike with screws provided.
Re-pinning instructions
2. To re-pin cylinder remove lock from door.
Using 2 mm Allen wrench, remove cylinder retaining set screw as shown.
Insert key and turn 90º CW and pull key to extract cylinder and retainer from lock.
Remove retainer from cylinder and re-pin as typical dead bolt cylinder.
Reverse steps to reassemble.
INSTALLATION INSTRUCTIONS
for 1655 Locker Lock
Tools
#2 Phillips Head Screwdriver
Door Preparation
1. Prepare reinforced door and frame to template 4696.
2 mm
Copyright © 2011, Sargent Manufacturing
Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in
part without the express written permission of
Sargent Manufacturing Company is prohibited.
A8101:B 9-30-11
Spacers
Note: the number of spacers used depends
on the thickness of the door.