SARGENT 4370 - 4379 Key Switches - Manual

4397HP Jamb Switch Box
INSTALLATION INSTRUCTIONS
FOR ASSISTANCE, CALL SARGENT AT 1-800-727-5477.
© SARGENT Manufacturing Company 2006 A7866A
1
STEP 1
Determine switch mounting location based on
mounting surface construction, applicable standards
and intended use.
Step 2.
Punch out the two mounting holes in the bottom of
the jamb switch box in the areas provided. Use caution
not to damage any electronics present in the box. For
hardwired applications, also punch out the wiring
access hole.
Step 3.
Drill holes for intended fastener in mounting surface
using the mounting box as your template. In hardwired
installations, drill a wiring access hole.
Step 4.
Insert the appropriate fastener through the box and
into the mounting surface and tighten securely.
Step 5.
In hardwired installations, wire the jamb switch to
the door controller using the NO and COMMON
contacts. For radio-controlled installations, wire the
jamb switch to the transmitter using the NO and
COMMON contacts.
Step 6.
Use the enclosed wrench to tighten the #6-32 screws
into the jamb box (as shown above-right).
Step 7.
Test for activation.
Observe all manufacturers recommendations for safety and
operation of their products. ANSI/BHMA standards that offer
specific recommendations for each type and class of automatic
door have been developed. To obtain a copy of the ANSI/BHMA
standard that applies to your installation, visit
www.buildershardware.com or www.ansi.org.
Jamb Switch
Deluxe Jamb Switch
Deluxe Jamb Switch
Jamb Switch Box