SARGENT MPower 4000 - Manual (Page 2)

5. Terminate wires as follows:
Red Wire (+) - Terminal 18
Black (-) - Terminal 17
Green (N.O.) - Terminal 9
White (C) - Terminal 8
Note: The Model 4315 Receiver antenna may be
left underneath or inside the 2600 Door Operator.
3. Continue routing the jacketed cable
below the transformer and underneath
the 120VAC terminal block.
4. Bring wires from below the 120VAC
terminal block and around to the main
Control Board.
Programming the Model 4310/4313 Transmitter and Model 4315 Receiver
Enter Learn Mode
Deleting a Transmitter Code from the
Receiver Memory
• Enter Learn Mode by pressing and holding the Mode
Switch button for 3 seconds, the Receiver LED will
flash fast
• Press again the Mode Switch button for 3 seconds.
The Receiver LED will flash 2 times to indicate cleared
memory
Model 4315 Receiver, LED Indicator
Operation
• Steady “ON” - Receiver is receiving an RF signal from
the coded transmitter
• Fast Flash - Learn Mode
• One Flash - Transmitter Code is learned
• Two Flashes - All learned codes are cleared
1. Press and hold the Mode Switch button
for 3 seconds. The Receiver LED will
flash fast.
2. Within 15 seconds of pressing the Mode button,
press the Model 4310/4313 Transmitter button.
The Model 4315 Receiver LED will flash 1 time
when the transmitter code is learned.
4315 Terminal Designation
4310 Shown
Copyright © 2009, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A7446B