SARGENT 351 EHT/EHTD Electromechanical Closer-Holder - Manual

1
Left Hand
Shown
1
NOTE: AN AUXILIARY DOOR STOP IS REQUIRED AT HOLD OPEN
CAUTION:
1. DISCONNECT ALL POWER BEFORE INSTALLATION
2. ALL WIRING TO BE PERFORMED BY QUALIFIED PERSONNEL TO
COMPLY WITH ALL APPLICABLE LOCAL CODES.
3. MAXIMUM WIRE SIZE IS 18 AWG.
!
2
351 closers are non-handed, RH must be on top for right hand
doors and LH must be on top for left hand doors.
3 Attach conduit adapter to track with nut provided.
Secure cable or conduit (by others) per local codes.
4
Secure track to frame with electronics toward hinge with screws
provided. Install hole plugs into exposed holes in track.
5 Connect 24VDC/VAC to terminal block marked “+”, “-”
and “GND” (if applicable). (NOTE: GND used if AC is
used).
+
-
G
N
D
On/Off
Switch
6
Use template from page 3; drill and tap door and frame for 12-24 machine screws, and prepare hole for conduit.
Do not drill through channel, as damage will occur voiding warranty.
7 Use screw and washer to secure main arm to spindle with index
mark as shown. Wire through fire alarm contact OR
Optional “Remote Release” switch is used.
Fire alarm contact
by others or
optional remote
release switch
Install closer body to door with spring power nut away
from hinge.
Spring
Power
Nut
COVER PLATE
INSTALLED
AFTER WIRING
Hole Plug
Index
mark on
spindle
45°
Index mark
on spindle
45°
Positioning of arm when
assembling to spindle
Hinge
Hinge
R. H. Door L. H. Door
Closer Spindle, Washer
and Screw
R. H. L. H.
WARNING:
IF NOT PROPERLY INDEXED,
DOOR CLOSER WILL NOT
FUNCTION PROPERLY.
A7655A
INSTALLATION INSTRUCTIONS
351 EHT Electromechanical Closer-Holder Device –
Pull Side
CAUTION: FAILURE TO INSTALL OR ADJUST PROPERLY MAY RESULT IN INJURY OR DAMAGE.
FOR ASSISTANCE CONTACT SARGENT AT 800-810-WIRE (9473) or www.sargentlock.com
Copyright © 2009, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company
is prohibited.