SARGENT 351 Series Aluminum Closer - Manual (Page 6)

FRAME
DOOR
COVER
SARGENT 1430
SERIES CLOSER
SHOWN. (OTHER
SERIES SIMILAR)
DOOR STOP
MORTISE NUT HEAD
DRILL 3/8" DIA.
HOLE FOR MORTISE
NUT BODY.
DRILL 1/4" DIA. HOLE
FOR MOUNTING SCREWS
1. SEE INSTRUCTIONS OR DATA SHEET PACKED WITH DOOR CLOSER FOR DIMENSIONS LOCATING THE CLOSER BODY AND FOOT ON DOOR AND FRAME.
2. MORTISE NUT SHOWN IS DESIGNED FOR AN UNREINFORCED METAL DOOR.
4. FOR DOORS 2 1/4" THICK: MORTISE NUT SHOWN FOR 1 3/4" THICK DOORS WILL BE FURNISHED ALONG WITH APPORPRIATE LENGTH THRU-BOLTS.
DOOR CONSTRUCTION MUST PROVIDE A BRIDGE TYPE REINFORCEMENT TO PREVENT THE DOOR RAIL FROM COLLAPSING WHEN THRU-BOLTS
ARE TIGHTENED.
3. FOR TOP JAMB AND CORNER BRACKET APPLICATIONS: THE DOOR CLOSER FOOT WILL BE ATTACHED TO THE DOOR IN A MANNER SIMILAR TO THAT
SHOWN FOR MOUNTING THE CLOSER BODY.
FRAME
VIEW "Y"
DOOR
1/8"
5/8" DIA. HOLE
SHORTEN MORTISE
NUT BODY TO
THIS LENGTH
1/4" DIA.
DRILLED HOLE
351 DOOR CLOSER SHOWN
(TRACK ASSEMBLY
MOUNTING IS SIMILAR)
3/8" DIA. HOLE
MORTISE NUT
HEAD
DOOR
STOP
9/16"
DIA.
7/64"
MORTISE NUT
1 11/16" FOR 1 3/4" THICK DOOR
1 5/16" FOR 1 3/8" THICK DOOR
(SEE NOTE #4 FOR 2 1/4" THICK DOORS)
#12-24 THREAD
SARGENT 351 SERIES SHOWN
SEE NOTE #1 BELOW FOR DIMENSION
INFORMATION. IF A DIMENSION LESS THAN
7/8" IS USED. THE DOOR STOP MUST BE CUT
TO CLEAR THE MORTISE NUT HEAD OR THE
MORTISE NUT HEAD MUST BE RECESSED.
(SEE ENLARGED VIEW "Y")
Copyright © 2009, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A7342A
USING MORTISE NUTS WITH SARGENT DOOR CLOSER
6